C Style Flex-Flex Couplings
The C Form coupling includes two flex hubs, one particular sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Variety Flex-Rigid Couplings
The CFR Style coupling consist of a single flex hub, a single rigid hub, 1 sleeve, one accessory kit consisting of seals and snap rings.
Capabilities
Simple and low-cost form of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Offered as vertical and horizontal couplings
Wide number of distinctive variations for instance full-flex, flex-rigid mill motor
Typical configurations can be found of your shelf
Ordering Information and facts
Application: Driver and Driven.
Kind and dimension of coupling, horizontal, vertical etc.
Power: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Form Couplings
Ordering Info
Puller Holes are regular on sizes 4 by way of twelve.
Puller Holes are available for sizes 7/8 by means of three.5 at an additional charge.
The BSE (distance Among Shaft Ends) might fluctuate concerning G and G1.
Interference bores without set screws are conventional unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Area.
More substantial sizes are available, please seek advice from Technical Assistance.
C and CFR Variety Effectiveness Information
Tags: