Electrical power UNITS FOR LIFT TABLE 1
Standard Description
This electrical power unit is developed solely to the little lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit continues to be broadly utilized in the market of logistic gadgets for instance minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed from the solenoid valve with all the speed controlled through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This power unit is made solely for the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the pace controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, but the power provide is cut, the lowering movement is controlled from the manual override perform.
Power UNITS FOR LIFT TABLE three
Basic Description
This power unit is created solely for your huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and the speed managed by a strain compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This power unit is intended exclusively for your huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve plus the velocity managed by the adjustable needle valve. When the lift rises to a large positoin, but the electrical power provide is minimize, the reducing movement is managed through the guide override perform.
Special Notes
1. This electrical power unit is of S3 duty cycle, which might only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic components concerned just before set up of the electrical power unit.
3. Viscosity in the oil shoud be 15~46 cst,which really should also be clean and cost-free of impurities.N46 hydraulic oil is advisable.
4. Oil transforming is required after the original one hundred operation hours,afterwards the moment every single 3000 hours.
five. The electrical power unit proven is created to be mounted vertically.
Electrical power UNITS FOR LIFT TABLE
Tags: